Mylex PCI to Ultra 160 SCSI RAID Controller AcceleRAID 170 Guia de Instalação Página 63
- Página / 82
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Glossary
Manual No. DB11-000022-00 G-9
controller to “rebuild” the data on the new drive, all without interrupting
system operations. Once the rebuild is complete, the controller will be
brought back into a fault tolerant state. See also Hot Swap.
Hot Spare
A physical disk drive not part of a system drive that the controller can use to
automatically rebuild a critical system drive. The hot spare drive must have
at least as much capacity as the largest disk drive in the array or the rebuild
may not start. See also Hot Standby.
Hot Standby
A redundant component in a fault tolerant storage system that has power
applied and is ready to operate, but which does not perform its task as long
as the primary component for which it is standing by is functioning properly.
See also Hot Replacement of Disk and Hot Spare.
Hot Swap
The exchange of a replacement unit in a storage system for a defective unit.
The exchange requires human intervention, but the system can continue to
perform its normal functions (compare with Auto Swap, Cold Swap, and
Warm Swap). See also Hot Replacement of Disk.
In-Line Terminator
A plug attached to the end of a SCSI cable in order to initiate active
termination. Used when SCSI devices on the cable do not have built-in
termination. See also Active Termination.
Interface
A hardware or software protocol that manages the exchange of data between
the hard disk drive and the computer. The most common interfaces for small
computer systems are ATA (also known as IDE) and SCSI.
Internal RAID Controller
A controller circuit board that resides inside a computer or server. An
internal RAID controller resides on a bus, such as the PCI bus. Examples of
internal RAID controllers include the Mylex AcceleRAID and
eXtremeRAID families.
- AcceleRAID 170 1
- LSI Logic Corporation 3
- North American Headquarters 3
- Milpitas, CA 3
- 408.433.8000 3
- Declaration of Conformity 4
- Community of Europe 6
- Proprietary Rights Notice 8
- Document Description 8
- Disclaimer 8
- License Restriction 8
- Copyright Notice 8
- Trademark Acknowledgments 9
- About This Manual 11
- Caution 12
- WARNING 12
- Contents 13
- Introduction 15
- Operating System Support 17
- Standard Package Contents 18
- User-supplied Items 19
- Installation 21
- Installation Checklist 24
- Connectors, LEDs, and Jumpers 25
- D1 D2 D4 26
- Installation Process 28
- Preparing the SCSI Drives 30
- SCSI Termination 31
- SCSI ID Numbers 34
- SCSI Cabling 35
- Narrow with Wide SCSI Drives 36
- LVD with Single-ended Drives 36
- Controller Start-up 37
- BIOS Options 38
- Setting BIOS Options 39
- Operating System 41
- In Case of Problems 42
- Specifications 43
- Error Messages 45
- Installation Abort 46
- System Reboot or Power Down 48
- PCI Hot Plug 49
- Implementation 50
- Enclosure Management 53
- Glossary 55
- Manual No. DB11-000022-00 G-3 57
- Manual No. DB11-000022-00 G-5 59
- Manual No. DB11-000022-00 G-7 61
- Manual No. DB11-000022-00 G-9 63
- Mirroring 66
- M.O.R.E 66
- Narrow SCSI 66
- RAID Levels 69
- SCSI Adapters 71
- SCSI Drive 71
- SCSI Drive States 71
- SAME DAC960 controller 73
- Stripe Order 74
- Stripe Size 74
- Stripe Width 74
- Striping 74
- LSI LOGIC CORPORATION 79
Vogel's 73202052 manuals
Owner’s manuals and user’s guides for Projector mounts Vogel's 73202052.
We providing 1 pdf manuals Vogel's 73202052 for download free by document types: Datasheet
Comentários a estes Manuais